Synergy Jeep JK Rear Track Bar

Part #: 8062X

Weight: 15.58 lbs

Description

Part #	Description
8062-02	JK Rear Track Bar
8068	JK Rear Track Bar (RHD)

8062-02

Bent to clear most aftermarket differential covers
Retains factory track bar mounting bolts & hardware
Made from high quality 1.50 inch x .250 wall DOM
Allows centering of rear axle when running a suspension lift
Suspension components feature an abrasion-resistant powder coat finish for maximum durability and corrosion resistance
Will fit 0-7" lifts (Rear track bar relocation bracket recommended for lifts over 2". See 8076 or 8056)
Synergy double adjuster sleeve & pinch bolt assembly allows for adjustment of track bar length without removing control arm mounting bolt
Features Synergy Dual Durometer Bushings (DDB) with Teflon® bearing surface for a maintenance free design focusing on performance, flex, longevity, and ride quality
100% bolt on components assures an easy, trouble free installation with the use of basic hand tools
Note: 8062 has been superseded by 8062-02

Includes:

(1) Grade 8 Pinch Bolts & Hardware
(1) Synergy Double Adjuster Sleeve
(1) Synergy Jeep JK Rear Track Bar

8068 (RHD)

Bent to clear most aftermarket differential covers
Retains factory track bar mounting bolts & hardware
Made from high quality 1-1/4" 1018 CR Solid Round Barstock
Allows centering of rear axle when running a suspension lift
Suspension components feature an abrasion-resistant powder coat finish for maximum durability and corrosion resistance
Will fit 0-7" lifts (Rear track bar relocation bracket recommended for lifts over 2". See 8076 or 8056)
Synergy double adjuster sleeve & pinch bolt assembly allows for adjustment of track bar length without removing control arm mounting bolt
Features Synergy Dual Durometer Bushings (DDB) with Teflon® bearing surface for a maintenance free design focusing on performance, flex, longevity, and ride quality
100% bolt on components assures an easy, trouble free installation with the use of basic hand tools

Includes:

(1) Grade 8 Pinch Bolts & Hardware
(1) Synergy Double Adjuster Sleeve
(1) Synergy Jeep JK Rear Track Bar

Notes:

8062-02 - The replacement adjustable joint is 4811-01 and the replacement bushings is 4327-01
8068 - The replacement adjustable joint is 4802-31 and the replacement bushings is 4323-01
RHD = Right Hand Drive

Min/Max Lengths:

Measured in a straight line from center of bolt hole to center of bolt hole

MAX EXTENDED LENGTH: 40.500"
MIN COLLAPSED LENGTH: 39.750"

8062-02 and 8068-RHD Installation Instructions

WARNING: Operating, servicing and maintaining a passenger vehicle or off-road vehicle can expose you to chemicals including engine exhaust, carbon monoxide, phthalates, and lead, which are known to the State of California to cause cancer and birth defects or other reproductive harm. To minimize exposure, avoid breathing exhaust, do not idle the engine except as necessary, service your vehicle in a well-ventilated area and wear gloves or wash your hands frequently when servicing your vehicle.
For more information go to www.P65Warnings.ca.gov