Synergy Jeep JK Weld-On Rear Track Bar Bracket

Part #: 8072-01
Weight: 7 lbs
  • MSRP: $95.00
Purchase through our Dealer Network.
Northridge4x4 4Wheel Drive Hardware 4 Wheel Parts QUADRATEC Morris 4x4 Center ORW - Off Road Warehouse CJC Offroad HB Performance OC Motorsports

*Not all products available from each dealer. For a list of international dealers click here.

  • Weight
    7 lbs
  • SKU
    8072-01
  • Synergy JK Weld-On Rear Track-Bar Bracket
  • Weld-On rear track-bar bracket designed to replace the weak factory JK track bar bracket
  • Replace the thin factory brackets on a stock axle or use for swapping any axle into a JK
  • Multiple Track-bar holes for suspension adjustments
  • Designed to fit stock JK axle tubes, 3.150" diameter
  • Will fit other diameter axle tubes with minor trimming
  • Track bar relocation bolt holes are 2.900", 3.713", and 4.525" above the stock track bar mounting location. 

Note: Requires the use of a minimum 3" bump stop spacer

Note: This bracket requires the use of a minimum 3" rear bump stop spacer for clearance with the exhaust. When using a lower relocation bolt hole or aftermarket exhaust, a shorter bump stop spacer may be used

Installation InstructionsReference Drawing

WARNING: Operating, servicing and maintaining a passenger vehicle or off-road vehicle can expose you to chemicals including engine exhaust, carbon monoxide, phthalates, and lead, which are known to the State of California to cause cancer and birth defects or other reproductive harm. To minimize exposure, avoid breathing exhaust, do not idle the engine except as necessary, service your vehicle in a well-ventilated area and wear gloves or wash your hands frequently when servicing your vehicle.
For more information go to www.P65Warnings.ca.gov

Related products

Drop items here to shop
Product has been added to your cart