Synergy Jeep JL / JLU / JT Steering Box Bolt Kit

This bolt kit is required to install the Synergy Jeep JL / JLU / JT front track bar and sector shaft brace kit (# 8869-01) on your Jeep JL / JLU / JT with updated cast iron steering box. Due to Chrysler’s recent TSB# 08-074-20 REV. B, this hardware kit is required for vehicles using the updated (cast iron) steering box and a sector shaft brace. If the vehicle features an aluminum steering box, then the factory steering gear box bolts are sufficient for securing the Synergy Jeep JL / JLU / JT front track bar and sector shaft brace kit (# 8869-01) to the frame rail of the vehicle. If the vehicle features a cast iron steering box and you are installing a sector shaft brace, then the four factory steering gear box bolts are not sufficient due to their length, and will need to be replaced with this bolt kit.

Fitments:

• 2018+ Jeep Wrangler JL / JLU
• 20+ Jeep JT Gladiator

Features:

• (4) 10.9 grade steel M12 - 1.50 x 120mm hex cap bolts with zinc finish
• (4) 10.9 grade steel Washers 

Notes:

Required to be installed with a Sector Shaft Brace

Chrysler Technical Service Bulletin 08-074-20 REV. B

More information: www.p65warnings.ca.gov