Synergy Jeep JK Weld-On Rear Track Bar Bracket

Features:

• Synergy JK Weld-On Rear Track-Bar Bracket
• Weld-On rear track-bar bracket designed to replace the weak factory JK track bar bracket
• Replace the thin factory brackets on a stock axle or use for swapping any axle into a JK
• Multiple Track-bar holes for suspension adjustments
• Designed to fit stock JK axle tubes, 3.150" diameter
• Will fit other diameter axle tubes with minor trimming
• Track bar relocation bolt holes are 2.900", 3.713", and 4.525" above the stock track bar mounting location. 

Note: Requires the use of a minimum 3" bump stop spacer

Note: This bracket requires the use of a minimum 3" rear bump stop spacer for clearance with the exhaust. When using a lower relocation bolt hole or aftermarket exhaust, a shorter bump stop spacer may be used

Installation InstructionsReference Drawing

More information: www.p65warnings.ca.gov